LASER ENGRAVER ROTARY CHUCK

•Small in size, works from both directions to save some time, It is possible to install one chuck or both together to save some time and drill two parts at the same time.

https://www.youtube.com/watch?v=OR5oWseC-ZI

•3-jaw chuck 50mm is suitable for catching small parts during the laser engravings process, such as rings, wooden pens, and anything with a diameter of 25 mm or less.

•The three self-centering jaws are reversible to allow the holding of larger workpieces. jaws installed in order 1, 2, and 3 to match the numbers on the housing. To fit them reversed, insert them in the order 3,2,1. Fit the slider plate into the housing and place the Circlips over the shaft to secure it. Turn the slider over so that the front end of the slider is about to pop into one of the slots. Feed into Jaw 1, large end first, and rotate the slider plate to snap it. Repeat with Jaw 2 in the next hole, then Jaw 3 in the next hole.

•There are three versions of jaws that you can choose between to suit your needs.

•For high envelope stability, the printed 30x1.5mm Plain External Circlips can be replaced with a metal steamer.

•It can be printed with any filament.

•The file contains 23 compressed files for each part and the assembly method is shown in the video
https://www.youtube.com/watch?v=cu8d6MDAeH8